U.S. Code · Título 42
Prohibition on use of lead pipes, solder, and flux
42 U.S.C. § 300g–6
Office of the Law Revision Counsel · release 119-142
Se muestra el texto operativo de la sección. Las notas estatutarias y el historial de enmiendas están en la fuente oficial.
In general
Prohibitions
In general
No person may use any pipe, any pipe or plumbing fitting or fixture, any solder, or any flux, after June 19, 1986, in the installation or repair of—
Leaded joints
Subparagraph (A) shall not apply to leaded joints necessary for the repair of cast iron pipes.
Public notice requirements
In general
Each owner or operator of a public water system shall identify and provide notice to persons that may be affected by lead contamination of their drinking water where such contamination results from either or both of the following:
Contents of notice
Notice under this paragraph shall provide a clear and readily understandable explanation of—
Unlawful acts
Effective 2 years after August 6, 1996, it shall be unlawful—
Exemptions
The prohibitions in paragraphs (1) and (3) shall not apply to—
State enforcement
Enforcement of prohibition
The requirements of subsection (a)(1) shall be enforced in all States effective 24 months after June 19, 1986. States shall enforce such requirements through State or local plumbing codes, or such other means of enforcement as the State may determine to be appropriate.
Enforcement of public notice requirements
The requirements of subsection (a)(2) shall apply in all States effective 24 months after June 19, 1986.
Penalties
If the Administrator determines that a State is not enforcing the requirements of subsection (a) as required pursuant to subsection (b), the Administrator may withhold up to 5 percent of Federal funds available to that State for State program grants under section 300j–2(a) of this title.
Definition of lead free
In general
For the purposes of this section, the term “lead free” means—
Calculation
The weighted average lead content of a pipe, pipe fitting, plumbing fitting, or fixture shall be calculated by using the following formula: For each wetted component, the percentage of lead in the component shall be multiplied by the ratio of the wetted surface area of that component to the total wetted surface area of the entire product to arrive at the weighted percentage of lead of the component. The weighted percentage of lead of each wetted component shall be added together, and the sum of these weighted percentages shall constitute the weighted average lead content of the product. The lead content of the material used to produce wetted components shall be used to determine compliance with paragraph (1)(B). For lead content of materials that are provided as a range, the maximum content of the range shall be used.
Plumbing fittings and fixtures
In general
The Administrator shall provide accurate and timely technical information and assistance to qualified third-party certifiers in the development of voluntary standards and testing protocols for the leaching of lead from new plumbing fittings and fixtures that are intended by the manufacturer to dispense water for human ingestion.
Standards
In general
If a voluntary standard for the leaching of lead is not established by the date that is 1 year after August 6, 1996, the Administrator shall, not later than 2 years after August 6, 1996, promulgate regulations setting a health-effects-based performance standard establishing maximum leaching levels from new plumbing fittings and fixtures that are intended by the manufacturer to dispense water for human ingestion. The standard shall become effective on the date that is 5 years after the date of promulgation of the standard.
Alternative requirement
If regulations are required to be promulgated under subparagraph (A) and have not been promulgated by the date that is 5 years after August 6, 1996, no person may import, manufacture, process, or distribute in commerce a new plumbing fitting or fixture, intended by the manufacturer to dispense water for human ingestion, that contains more than 4 percent lead by dry weight.
Public education
In general
The Administrator shall make information available to the public regarding lead in drinking water, including information regarding—
Vulnerable populations
In making information available to the public under this subsection, the Administrator shall, subject to the availability of appropriations, carry out targeted outreach strategies that focus on educating groups within the general population that may be at greater risk than the general population of adverse health effects from exposure to lead in drinking water.
(July 1, 1944, ch. 373, title XIV, § 1417, as added Pub. L. 99–339, title I, § 109(a), June 19, 1986, 100 Stat. 651; amended Pub. L. 104–182, title I, § 118, title V, § 501(f)(1), Aug. 6, 1996, 110 Stat. 1645, 1691; Pub. L. 111–380, § 2(a), Jan. 4, 2011, 124 Stat. 4131; Pub. L. 113–64, § 2, Dec. 20, 2013, 127 Stat. 668; Pub. L. 114–322, title II, § 2106(b), Dec. 16, 2016, 130 Stat. 1726.)